GW Instek GOS-652G - Manual (Page 20)

⎯ 15 ⎯
B : Display the delayed sweep(B sweep) alone.
B TRIG‘D : Select between continuous delay and triggered delay.
Disengaged : For continuous delay. The B sweep starts immediately after the sweep delay time set by A
TIME/DIV and B TIME/DIV switch and DELAY .TIME knob has elapsed.
Engaged : For triggered delay. The B sweep starts when the triggering pulse is applied after the sweep delay
time set by A TIME/DIV and B TIME/DIV switch and DELAY TIME knob has elapsed.
(The triggering signal is used in common for both A sweep and B sweep).
X-Y.................……….........(27)
Press the X-Y button to enable X-Y operation.
Others
CAL……….....………..........(1)
This terminal delivers the calibration voltage of 2 Vp-p, 1kHz, positive square wave. The output resistance is 2k ohm see
page 5 technical specification for tolerance.
GND................………….....(20)
Ground terminal of oscilloscope mainframe.
Readout Function (Only available in 626G & 658G)
CURSOR measurement........(32)
CURSOR ON/OFF : Press the button to turn on/off the cursor measurement.
CURSOR FUNCTION : Press the button to select the measurement functions.
∆V
: Voltage difference measurement.
∆V%
: Voltage difference measurement in percentage(5 div =100% ref.)
∆VdB
: Voltage gain measurement(5 div = 0dB ref. ,
∆VdB = 20 log∆div/5div)
∆T
: Time difference measurement.
1/
∆T
: Frequency measurement.
DUTY : Duty cycle or time difference percent(
∆T%) measurement(5 div =100% ref.)
PHASE : Phase measurement(5 div = 360
° ref.)