GW Instek GOS-652G User Manual
Page 33
⎯ 28 ⎯
Cursor Measured Value Display
The relative measured values of the seven functions are displayed at (7).
(a)
…
…Shows each of seven functions ( △V, △V%, △VdB, △T, 1/△T, DUTY, PHASE ) which may be selected by the CURSOR
FUNCTION button. The △ V function provide different △ V ( △ V1, △ V2, △ V12, △ Vy, △ Vy1 )
according to the following table：
VERT. MODE
CH1
CH2
DUAL
ADD
CH1
△V1
CH2
LINE
TRIG.
SOURCE
EXT
△V1
△V2
△V2
△V12
X-Y
*1
△ Vy
△Vy1
*1
NOTE：
*1：When X-Y mode is not set at correct position, the error message
“X-Y mode error ”is shown.
(b)……In the △V function, a “ + ” or “ - ” polarity is shown. “+ ”when the ▽(delta) cursor is above the ▼ (REF.) cursor; “- ”when
the ▽(delta) cursor is below the ▼ (REF.) cursor.