beautypg.com

Figure 4-13, Figure 4-14 – GW Instek GOS-652G User Manual

Page 31

background image

⎯ 26 ⎯

Figure 4-13

HORIZ DISPLAY
A INTEN

Figure 4-14

HORIZ DISPLAY
B INTEN

A

Sweep

B

Sweep

Sweep

delay time

B trigger level

This start point moves discretely

A INTEN

Figure 4-15

4.11 Readout Function (626G and 658G)

The selected sensitivity, input, sweep time, etc.. are displayed in the positions as shown in Figure 4-16.

NOTE:The CRT will not show any trace or spot when the TRIGGER MODE is in NORM state. To observe the signals, depress the AUTO
button.

CH1 Display

When the VERT MODE switch is at CH1, DUAL or ADD state, the set values of CH1 are displayed at

(1).

However, these values

are not shown when the VERT MODE is at CH2.

(a)……“ P10 ” sign is shown when the probe ×10 is setted.
(b)……“> ” sign is shown when the V/DIV VAR. is at UNCAL position.
(c)…… Display the selected sensitivity from 1mV to 5V. (Probe x10 from 10mV to 50V)
(d)……“x ” sign is displayed when the X-Y button is set and the VERT MODE is at CH2. At DUAL X-Y mode, “y1 ”is displayed.

This manual is related to the following products: