Fire-Lite LDM-32F Lamp Drivers - Manual (Page 40)

Appendix A: Sensiscan 2000 Control Switch Operation
40
LDM-32F PN 50055:C 03/20/01
Control Switch Operation
Circuit corresponds to a specific I/O module installed in user configured
Sensiscan 2000.
The first 8 control switches of the LDM-32F will correspond to CPU switch
functions as shown below, if “8-Point Shift” is not selected.
With “8-Point Shift” selected, the first 8 control switches move to the 3rd LDM-
E32F and are assigned to Circuits 57 through 64 as shown below.
Note: It is assumed that Sensiscan 2000 systems with “8-Point Shift” selected will be 56
zones/points or less.
Table 10 Switch Control Functions
Switch
Position
LDM-32F ----- 3rd LDM-E32F
1 Acknowledge Not Used
2 Signal Silence Not Used
3 System Reset Not Used
4 Not Used Not Used
5 NAC #1 Not Used
6 NAC #2 Not Used
7 Municipal Tie Not Used
8 Alarm Relay Not Used
9 Not Used Acknowledge
10 Not Used Signal Silence
11 Not Used System Reset
12 Not Used Not Used
13 Not Used NAC #1
14 Not Used NAC #2
15 Not Used Municipal Tie
16 Not Used Alarm Relay