Edwards Signaling Integrity Synchronized Temporal Horn-Strobe User Manual

Page 2

2 / 6

P/N 3100376 • REV 6.0 • ISS 06MAY11

To install the temporal horn-strobe:

1. Select and install a suitable electrical box. See “Mounting

the electrical box” on page 3 for details.

Note: Outdoor installations require a weatherproof
backbox.

2. Set the horn volume and tone. See “Selecting the volume

and tone” on page 3 for details.

3. Bring the signal circuit field wiring into the electrical box.

4. Position the mounting plate on the electrical box with the

hook flange up and facing outward as shown in Figure 1.
Fasten the plate using screws provided with the electrical
box.

5. Connect the signal circuit field wiring. For the unit to

function properly, observe polarity.

To connect the horn and strobe on the same circuit, see
Figure 2. To connect the horn and strobe on different
circuits, see Figure 3.

For additional wiring details, see the installation
instructions for the signaling modules or circuits used in
the fire alarm control panel.

6. After completing the connections, attach the unit to the

mounting plate, as noted below.

a. The grille has tabs (at the top of the inner face) that

engage with the hook flange on the mounting plate.
Angle the bottom of the grille out slightly, and slide the
unit into place so that the tabs engage the flange.

b. Seat the grille by pressing the bottom in.

c. Fasten the bottom of the grille to the mounting plate

by tightening the captive locking screw.

7. Apply power and activate the unit to verify that it is

operating properly.

Figure 1: Mounting diagram

5-59/64 in.

(150 mm)

3-13/32 in.

(87 mm)

5-59/64 in.

(150 mm)

5/8 in.

(16 mm)

2-1/8 in.

(54 mm)

5-5/8 in.

(143 mm)

5-5/8 in.

(143 mm)

3-5/16 in

(84 mm)

(1)

(3)

(4)

(5)

(2)

(6)

(7)

(8)

(9)

5-1/2 in.

(140 mm)

5-1/2 in.

(140 mm)

R
E

(1) Gasket
(2) Weatherproof

box

(3) Standard

box

(4) Knockouts for 1/2 in. (13 mm) or 3/4 in. (19 mm) conduit top,

bottom, back

(5) Surface mount box
(6) Mounting plate (supplied)
(7) #8-32

screw

(8) Captive locking screw
(9) Hook

flange