Detcon PI-700 0-500ppb - Manual (Page 21)

Model PI-700 0-500ppb
PI-700 0-500ppb Instruction Manual Rev. 0.0 Page 17 of 53
remaining sensor life, gas factor, zero offset, mA output, input voltage, sensor ambient temperature, gain
setting, and the sensor’s raw counts.
From the View Sensor Status text scroll, hold the magnet over PGM1 or PGM2 until the “V” prompt appears
and continue to hold the magnet in place for an additional 3-4 seconds (until the display starts to scroll “Status
Is”). The display will scroll the complete list of sensor status parameters sequentially:
Sensor Model Type
The menu item appears as: “Model PI-700”
Current Software Version
The menu item appears as: “Version 1.XX”
Gas Type
The menu item appears as: “ Gas Type = VOC”
Range of Detection.
The menu item appears as: “Range XXX”
Serial ID address.
The menu item appears as: “Serial ID XX”
AutoSpan Level.
The menu item appears as: “AutoSpan Level XX”
Days Since Last AutoSpan.
The menu items appears as: “Last Cal XX days”
Remaining Sensor Life.
The menu item appears as: “Sensor Life 100%”
Gas Factor
The menu item appears as: “Gas Factor X.X”
Zero Offset
The menu item appears as: “Zero Offset X.X”
mA Output
The menu item appears as: “mA Output XX.XX”
Input Voltage Supply
The menu item appears as: “Voltage XX.X VDC”
Sensor Temperature
The menu item appears as: “Temp XX C”