Triton FT5000 X2 User Manual - Manual (Page 49)

C-3
A
PPENDIX
C - C
OMBINATION
L
OCKS
B
ATTERY
L
OW
W
ARNING
Repeated beeping during an opening indicates that the battery is low or dead and needs to be replaced.
The battery box is located on the inside of the door.
Note: If the lock will not operate (i.e. repeated beeping or no beeping) while the door is closed and locked,
the battery must be energized from the two external terminals on the front of the push-button panel.
To energize the lock, connect a 9-volt alkaline battery on the external terminal points. Maintain contact,
enter a valid combination, and turn the dial clockwise to open the lock.
Note: You must maintain battery contact at all times throughout this procedure.
C
HANGING THE
B
ATTERY
1. Open the ATM vault door. Remove the battery box cover by
pulling the front portion away from the vault door.
2. The connector is easily removed by unsnapping it from the
two (2) terminal on the top of the battery.
3. Remove the old battery. Install/connect a new 9-volt alkaline
battery.
4. Push the battery and the leads completely up into the battery
compartment.
5. Reinstall the cover and test the unit several times before
closing the vault door.