Spectra Precision ADLCONF User Guide - Manual (Page 34)

34 ADLCONF User Guide
kHz-wide channel table, will receive the 12.5 kHz signal without any problem.
Restoring Factory Settings
Different ADL radio products use different default configuration settings. Regardless of
how you reconfigure an ADL radio, it always remembers the original default settings. To
restore the radio settings to the factory default settings, click
Restore Factory on the right
of the ADLCONF screen or select Edit / Restore Factory Defaults:
The ADLCONF software must first connect (or reconnect) to the radio. For more
information, see
Connecting to the Radio, page 9 . If the ADLCONF software is already
displaying a radio configuration, the following message appears:
Click Yes to copy the default settings from the radio’s permanent memory to the
computer’s memory for review and editing. No changes are made to the configuration
the radio will use until you click either the
Program button on the main screen or the
Program button on the Exit dialog. When restoring factory defaults, the ADLConf
software keeps the current channel table.
Undoing Changes to Radio
Settings
To undo all configuration changes entered in the current session of the ADLCONF
software, click
Undo Changes or select Edit / Undo All Changes.
This action cancels all the configuration changes you have made during the session. All
settings on the ADLCONF screens are reset to those that were in effect when you started
this session.
Click Undo Changes does not affect any settings in the radio or any configuration file
on your computer. The only way to change the configuration of the radio is to first make
them in the ADLCONF software and then click
Program .