Seed Hawk 30 SERIES 2015 - Manual (Page 53)

SEED HAWK ® 2015 30 SERIES OPERATOR’S MANUAL – DOMESTIC 48
3. Set to the desired shaft speed and
select
“Prime”.
4. Meter will turn 2 revolutions to
ensure meter roller is full of product.
5. Empty product from calibration
bucket caught during the Prime cycle.
Reposition calibration bucket under
meter and select “Calibrate”. 6. Meter will begin to turn. Stop the
meter by selecting "Continue".
7. Enter the total weight of product
caught minus the weight of the empty
calibration bucket.
8.Calibration for this meter is now
complete, repeat steps to calibrate
remaining meters. Select
"OK" when
finished.
ATTENTION! DO NOT include the weight of the calibration bucket in the
metered weight value.
The monitor MUST be powered down properly by pressing and holding the
Power Key until the monitor powers down. Failure to do so will result in lost
data.