Seed Hawk 30 SERIES 2015 User Manual

Page 47

SEED HAWK

2015 30 SERIES OPERATOR’S MANUAL – DOMESTIC

4. Remove a Sensor: Individual sensors can be removed by highlighting the
desired sensor and pressing the

Soft Key labeled “Remove.” Unplug the sensor

so that the computer does not try input it back into the system.

5. Sensor Settings: Specific information about each sensor installed on the
MuxBus system can be viewed by placing the highlight bar on the sensor and
pressing the

Soft Key labeled “Settings”. The monitor will display the sensor

type number, communication speed, and serial number. Sensors with a user
settable value have a dialog box that can be accessed to enter a value. To do this,
navigate to the dialog box and press the

Enter Key. A keypad dropdown box

will appear. Use the

Selector Knob or Navigation Keys to select the individ-

ual numbers you want to enter starting with the left most value.

NOTE: You must press the

Selector Knob to select

individual numbers. You must

press the

Enter Key to save

the complete value.

6. Ignore/Revive: Sensors can be temporarily disabled by placing the highlight
bar on the desired sensor Pressing the

Soft Key labeled "Ignore." Re-enable

that sensor by placing the highlight bar on the sensor and Pressing the

Soft

Key labeled "Revive." This disables a sensor if a part of the system is not being
used such as

an empty bin. Ignoring the sensor will eliminate unwanted alarms.