Seed Hawk 30 SERIES 2015 - Manual (Page 52)

SEED HAWK ® 2015 30 SERIES OPERATOR’S MANUAL – DOMESTIC 47
5.5.1 Pre-Calibration Setup
5.5 Meter Calibration
All meters must be individually calibrated. Calibrations must be done each time
a crop is changed. Calibration for the seed is done at the front hopper, on the
left side of the machine, and calibration for the fertilizer is done at the rear
hopper, on the right side of the machine. Measure and record the weight of the
empty calibration bag supplied.
1. Measure and record the weight of the empty calibration bag supplied.
Calibration Bag Weight: _________________
Once calibration bag is weighed, then attach the bag to the meter
5.5.2 Loup III Calibration Procedure
NOTE: It is important to cal-
ibrate as close to the actual
seeding rpm of the roller as
possible. Refer to Section 9.0
for the Seeding Table to get
an approximate roller rpm
for the specific roller and
drill width.
1. Navigate the highlight bar to "Meter
Calibration" from the Menu Settings. 2. Highlight the desired meter to
calibrate.