Safety considerations – LumaSense Technologies INNOVA 1309 User Manual

Page 5

Safety Considerations
________________________________________________________________________

________________________________________________________________________

BE1285-15

1309 Multipoint Sampler

LumaSense Technologies A/S

Page 5 of 42

All rights reserved. No part of this publication may be reproduced or distributed in
any form or by any means without prior consent in writing from LumaSense Tech-
nologies A/S, Ballerup, Denmark.

SAFETY CONSIDERATIONS

The 1309 Multipoint Sampler complies with EN/IEC 61010-1 3

Ed.

(2010): Safety requirements for electrical equipment for measurement,

control and laboratory use. To ensure safe operation and retain the 1309
in safe condition, note the following:

APPLYING POWER

Before using the 1309 check that the available mains voltage match the

specified voltage and frequency for the instrument.

SAFETY SYMBOLS

The apparatus is marked with this symbol when it is important that

the user refer to the associated warning statements given in the User

Manual.

Frame or Chassis

Protective earth

Hazardous Voltage

WARNINGS

Before connecting or disconnecting interface cables, switch off the power

to all instruments.

If the correct function or operating safety of the 1309 is impaired, secure
the instrument against further use until the fault is repaired.

Any adjustment, maintenance or repair of the internal parts of the 1309
under power must be avoided as far as possible; if unavoidable, it must

only be done by qualified service personnel.