LumaSense Technologies INNOVA 1309 - Manual (Page 19)

Chapter 2
________________________________________________________________________
________________________________________________________________________
BE1285-15 1309 Multipoint Sampler LumaSense Technologies A/S
Page 19 of 42
Note: some gases may be absorbed by the water trapped in the filter.
This will reduce the gases’ concentrations.
To connect sampling tubing to the water-trap filter
Push the sampling tubing into the connector as far as it will go and
tighten the nut.
Fig. 2.10 Attaching tubing to the In-line Genie Membrane Separator.
Note: make sure that the gas flows through the filter in the direction
indicated - shown by the arrows on the filter.
To disconnect the sampling tubing
Loosen the nut and pull the sampling tubing out of the connector.
2.4.4 Connecting the Sampler Outlet to the Gas Monitor
This connection uses the same tubing (PTFE, LumaSense No. AF0614)
as for the sampling tubes,
section 2.4.1 . The tubing is connected to the
Outlet to Analyzer stub on the rear panel of the 1309, and to the Air
Inlet stub on the rear panel of the Gas Monitor. The tubing is connect-
ed as described in section 2.4.1 .