LumaSense Technologies INNOVA 1309 - Manual (Page 14)

Chapter 2
________________________________________________________________________
________________________________________________________________________
BE1285-15 1309 Multipoint Sampler LumaSense Technologies A/S
Page 14 of 42
2.3.1 Setting the Interface Address of the 1309
The 1309 uses a single interface address. The address is set using the
bank of eight DIP switches on the rear panel of the 1309. The last five
switches on the bank decide the interface address. These switches are
marked A1 (the least significant bit) to A5 (the most significant bit).
The switches represent binary values, as follows:
If the switch is down, it represents a binary “0”. See Fig. 2.5.