3 limit of liability and warranty, 4 unpacking the instrument, 5 service request, repair, or support – LumaSense Technologies M330 User Manual
Page 6
M330 Manual
General Information 6
Do not attempt to operate with any of the safety features bypassed or disconnected.
Do not place this unit where it will be subject to excessive shock, vibration, dirt,
moisture, oil, or other liquids.
DANGER! Power is present even if the front panel circuit breaker is in the OFF (0)
position!
1.3 Limit of Liability and Warranty
All general information and notes for handling, maintaining, and cleaning this instrument are
offered according to the best of our knowledge and experience.
All Mikron blackbodies from LumaSense Technologies have a regionally effective warranty
period. Please check our website at
for up-to-date
warranty information. This warranty covers manufacturing defects and faults which arise during
operation, only if they are the result of defects caused by LumaSense Technologies.
The warranty is VOID if the instrument is disassembled, tampered with, altered, or otherwise
damaged without prior written consent from LumaSense Technologies; or if considered by
LumaSense Technologies to be abused or used in abnormal conditions.
1.4 Unpacking the Instrument
Note: This blackbody arrived in two packages; the main blackbody furnace (large box)
and the emitting cavity (small box). Refer to installation instructions.
When unpacking and inspecting your system components, you need to do the following:
1. Check all materials in the container against the enclosed packing list.
Note: LumaSense Technologies cannot be responsible for shortages against the
packing list unless a claim is immediately filed with the carrier. Final claim and
negotiations with the carrier must be completed by the customer.
2. Carefully unpack and inspect all components for visible damage.
3. Save all packing materials, including the carrier’s identification codes, until you have
inspected all components and find that there is no obvious or hidden damage.
Note: Before shipment, each instrument is assembled, calibrated, and tested at the
LumaSense Factory. If you note any damage or suspect damage, immediately contact
the carrier and LumaSense Technologies, Inc.
1.5 Service Request, Repair, or Support
Contact LumaSense Technologies Technical Support in case of a malfunction or service request.
Provide clearly stated details of the problem as well as the instrument model nµmber and serial
nµmber. Upon receipt of this information, Technical Support will attempt to locate the fault
and, if possible, solve the problem over the telephone.
If Technical Support concludes that the instrument must be returned to LumaSense Technologies
for repair, they will issue a Return Material Authorization (RMA) nµmber.
Return the instrument upon receipt of the RMA nµmber, transportation prepaid. Clearly
indicate the assigned RMA nµmber on the shipping package exterior. Refer to Section 1.6,
Shipments to LumaSense for Repair, for shipping instructions.
Technical Support can be contacted by telephone or email: