LumaSense Technologies BoilerSpection-IM Manual - Manual (Page 21)

BoilerSpection IM Manual BoilerSpection-IM Operation 21
Note: The camera wirelessly transmits the video signal on Channel 4. If you have
problems receiving an image, check that the display is set to receive on Channel 4.
Refer to the troubleshooting section of this manual for additional details.
4.2.1 Inserting the Battery
1. Remove the battery compartment cover in the back
of the hand held display as shown right.
2. Align the gold contacts of the supplied battery with
corresponding connectors on the hand held display.
3. Slide the battery in until it fits into place.
4.2.2 Charging the Battery
Before using the hand held display, the battery must be charged for at least 4 hours. However, the
display provided by LumaSense is already fully charged and can be used as is.
1. Control Port
2. Power Key
3. HOLD Key
4. REC Key
5. A/V Out
6. A/V In
7. DC In
8. USB Port
9. SD Card Slot
10. RESET
11. Photo Capture Key
12. IR Sensor
13. Volume Down
14. Volume Up
15. 5-Way Navigation Key
16. STOP/ESC Key
17. SET UP Key
18. REC Indication LED
19. 5V Camera In
20. Speaker
21. Power/Charge LED
22. Stand Holder
23. Battery Compartment