Configuring hdd group for recording and capture, 8 configuring hdd group for recording and capture – LT Security LTN8600 Series NVR (V2.3.2) User Manual
Page 79
User Manual of 9600/8600/7700/7600 Series NVR
79
5.8 Configuring HDD Group for Recording and
Capture
Purpose:
You can group the HDDs and save the record files and captured pictures in certain HDD group.
Steps:
1.
Enter HDD setting interface.
Menu>HDD
Figure 5. 27 HDD General
2.
Select Advanced on the left bar.
Figure 5. 28 Storage Mode
Check whether the storage mode of the HDD is Group. If not, set it to Group. For detailed information,
please refer to Chapter 11.4 Managing HDD Group.
3.
Select General in the left bar.
Click
to enter editing interface.
4.
Configuring HDD group.
1)
Choose a group number for the HDD group.
2)
Click Apply and then in the pop-up message box, click Yes to save your settings.
3)
Click OK to back to the upper level menu.
Repeat the above steps to configure more HDD groups.
5.
Choose the Channels which you want to save the record files and captured pictures in the HDD group.
1)
Select Advanced on the left bar.
2)
Choose Group number in the dropdown list of Record on HDD Group
3)
Check the channels you want to save in this group.
4)
Click Apply to save settings.
Note:
After having configured the HDD groups, you can configure the Recording and Capture
settings following the procedure provided in Chapter 5.2-5.7.