Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 43)

Configuring basic device settings
3
Brocade Mobility 7131N-FGR Access Point Installation Guide 35
53-1001948-01
CAUTION
Only a qualified wireless network administrator should set the access
point radio configuration. Refer to the Brocade Mobility 7131 Series
Access Point Product Reference Guide for an understanding of the
configurable values involved and their implications.
NOTE
Even an access point configured with minimal values must protect its data
against theft and corruption. A security policy should be configured for WLAN1
as part of the basic configuration outlined in this guide. A security policy can be
configured for the WLAN from within the Quick Setup screen. Policies can be
defined over time and saved to be used as needed as the access point’s
security requirements change. Brocade recommends you familiarize yourself
with the security options available on the access point before defining a
security policy.
9. Click Apply to save any changes to the Quick Setup screen. Navigating away
from the screen without clicking Apply results in all changes to the screens
being lost, unless you use the Un-applied Changes pop-up window to overwrite
the current settings.
10. Click Undo Changes (if necessary) to undo any changes made. Undo Changes
reverts the settings displayed on the Quick Setup screen to the last saved
configuration.
Configuring basic security
For testing basic connectivity, there is no reason to configure a server supported
authentication scheme. WPA2/CCMP is described in this guide as a basic security
scheme sufficient to protect the Brocade Mobility 7131N-FGR Access Point’s initial
transmissions. For details on configuring other authentication and encryption
options available to the access point, refer to the Brocade Mobility 7131 Series
Access Point Product Reference Guide.
AP7131N_InstallationGuide.book Page 35 Tuesday, August 24, 2010 5:09 AM