Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 27)

LED indicators
2
Brocade Mobility 7131N-FGR Access Point Installation Guide 19
53-1001948-01
The access point utilizes two different colored lights below each LED. Only one light
displays within a LED at any given time. Every light within each LED is exercised
during startup to allow the user to see if an LED is non-functional. The LEDs turn on
and off while rotating around in a circle. Since two LEDs feed each light pipe, the
pattern is from left to right, then right to left.
NOTE
The LED blink rate is proportional to activity. The busiest traffic corresponds to the
fastest blink, while the slowest traffic corresponds to slowest blink.
NOTE
Depending on how the 5 GHz and 2.4 GHz radios are configured, the LEDs will blink
at different intervals between amber and yellow (5 GHz radio) and emerald and
yellow (2.4 GHz radio).
The LEDs on the top housing of the access point are clearly visible in wall and below
ceiling installations. The top housing LEDs have the following display and
functionality:
AP7131N_InstallationGuide.book Page 19 Tuesday, August 24, 2010 5:09 AM