Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 25)

Mounting the access point
2
Brocade Mobility 7131N-FGR Access Point Installation Guide 17
53-1001948-01
8. Connect the light pipe to the bottom of the access point. Align the tabs and
rotate approximately 90 degrees. Do not over tighten.
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Place the decal on the back of the badge and slide the badge onto the light
pipe from the finished side of the tile.
11. Attach the antennas to their correct connectors.
For information on the antennas available to the access point, see “Antenna
options” on page 7.
CAUTION
Ensure you are placing the antennas on the correct connectors to
ensure the successful operation of the Brocade Mobility 7131N-FGR
Access Point.
12. Brocade recommends attaching safety wire to the access point safety wire tie
point or security cable (if used) to the access point’s lock port.
13. Align the ceiling tile into its former ceiling space.
14. Cable the access point using an approved line cord and power supply.
For standard power adapter and line cord installations:
AP7131N_InstallationGuide.book Page 17 Tuesday, August 24, 2010 5:09 AM