Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 10)

Warnings
1
2 Brocade Mobility 7131N-FGR Access Point Installation Guide
53-1001948-01
The two models available to the Brocade Mobility 7131N-FGR series include:
• BR-7131N-66040-FWW (802.11an and 802.11bgn capable)
• BR-7131N-66040-FGR (802.11a and 802.11bg capable)
Warnings
• Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the access point to its power source.
• Remove jewelry and watches before installing this equipment.
• Verify that the unit is grounded before connecting it to the power source.
• Verify that any device connected to this unit is properly wired and grounded.
• Connect all power cords to a properly wired and grounded electrical circuit.
• Verify that the electrical circuits have appropriate overload protection.
• Attach only approved power cords to the device.
• Verify that the power connector and socket are accessible at all times during
the operation of the equipment.
• Do not work with power circuits in dimly lit spaces.
• Do not install this equipment or work with its power circuits during
thunderstorms or other weather conditions that could cause a power surge.
• Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.
Site preparation
• Consult your site survey and network analysis reports to determine specific
equipment placement, power drops, and so on.
• Assign installation responsibility to the appropriate personnel.
• Identify and document where all installed components are located.
• Provide a sufficient number of power drops for your equipment.
• Ensure adequate, dust-free ventilation to all installed equipment.
• Identify and prepare Ethernet and console port connections.
AP7131N_InstallationGuide.book Page 2 Tuesday, August 24, 2010 5:09 AM