Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 17)

Mounting the access point
2
Brocade Mobility 7131N-FGR Access Point Installation Guide 9
53-1001948-01
CAUTION
An access point should be wall mounted to concrete or
plaster-wall-board (dry wall) only. Do not wall mount the access point to
combustible surfaces.
The hardware and tools (customer provided) required to install the access point on
a wall consists of:
• Two Phillips pan head self-tapping screws
(ANSI Standard) #6-18 X 0.875in. Type A or AB Self-Tapping screw, or
(ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-Tapping screw
• Two wall anchors
• Wall mount template (included on the next page)
• Security cable (optional third part provided accessory)
AP7131N_InstallationGuide.book Page 9 Tuesday, August 24, 2010 5:09 AM