Led indicators, Indicators – Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) User Manual
Page 26
LED indicators
2
18
Brocade Mobility 7131N-FGR Access Point Installation Guide
53-1001948-01
a. Connect a RJ-45 Ethernet cable between the network data supply (host)
and the access point’s GE1/POE or GE2 port.
b. Verify the power adapter is correctly rated according the country of
operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the access
point.
e. Attach the power supply line cord to a power supply.
CAUTION
Do not actually connect to the power source until the cabling portion of
the installation is complete.
15. Verify the behavior of the access point LED light pipe. For more information, see
16. Place the ceiling tile back in its frame and verify it is secure.
17. The access point is ready to configure. For information on basic access point
“Configuring basic device settings”
LED indicators
A Brocade Mobility 7131N-FGR Access Point access point has six LEDs on the top of
the access point housing, and one optional LED light pipe at the bottom of the unit.
However, a Brocade Mobility 7131N-FGR Access Point model access point does not
use LED 6, as no third radio is available. Five LEDs illuminate (on top of the
housing) for dual radio Brocade Mobility 7131N-FGR Access Point models.
AP7131N_InstallationGuide.book Page 18 Tuesday, August 24, 2010 5:09 AM