Brocade Access Gateway Administrator's Guide (Supporting Fabric OS v7.3.0) - Manual (Page 70)

Failback policy configurations in Access Gateway
The following sequence describes how a failback event occurs:
• When an N_Port comes back online, with the Failback policy enabled, the F_Ports that were
originally mapped to it are temporarily disabled.
• The F_Port is rerouted to the primary mapped N_Port, and then re-enabled.
• The host establishes a new connection with the fabric.
NOTE
The failback period is quite fast and rarely causes an I/O error at the application level.
Failback example
In Example 3, described below, the Access Gateway N_1 remains disabled because the
corresponding F_A1 port is offline. However, N_2 comes back online. See
Failover example on page
63 for the original failover scenario.
Failback policy configurations in Access Gateway
68 Access Gateway Administrator's Guide
53-1003126-01