About this document, Supported hardware and software, What’s new in this document – Brocade Access Gateway Administrator's Guide (Supporting Fabric OS v7.3.0) User Manual
Page 11
About This Document
Supported hardware and software
In those instances in which procedures or parts of procedures documented here apply to some switches
but not to others, this guide identifies which switches are supported and which are not.
Although many different software and hardware configurations are tested and supported by Brocade
Communications Systems, Inc., for Fabric OS, documenting all possible configurations and scenarios is
beyond the scope of this document.
All Fabric OS switches must be running Fabric OS v7.0.0 or later; all M-EOS switches must be running
M-EOSc 9.1 or later, M-EOSn must be running 9.6.2 or later, and Cisco switches with NX OS must be
running 5.x or later.
Fabric OS version 7.3.0 supports the following Brocade hardware platforms for Access Gateway:
•
Brocade 300
•
Brocade 5100
•
Brocade M5424
•
Brocade 5430
•
Brocade 5431
•
Brocade 5450
•
Brocade 5460
•
Brocade 5470
•
Brocade 5480
•
Brocade 6505
•
Brocade M6505
•
Brocade 6510
•
Brocade 6547
•
Brocade VA-40FC
What’s new in this document
The following information has been added since this document was last released:
•
AG mode is supported without all POD licenses.
•
Password distribution is supported.
•
Dynamic D_Port is supported.
•
FDMI is supported.
Access Gateway Administrator's Guide
9
53-1003126-01