Brocade Access Gateway Administrator's Guide (Supporting Fabric OS v7.3.0) - Manual (Page 29)

Default port mapping
When you first enable a switch for AG mode, the F_Ports are mapped to a set of predefined N_Ports by
default. The table below describes the default port mapping for all supported hardware platforms. By
default, Failover and Failback policies are enabled on all N_Ports.
If you want to change the default mapping, refer to Adding F_Ports to an N_Port on page 31. Note
that all F_Ports must be mapped to an N_Port before the F_Port can come online.
NOTE
Prior to Fabric OS 7.3.0, all POD licenses must be present to use the Brocade 300, 5100, 6505, and
6510 as an Access Gateway. However, Fabric OS 7.3.0 does not require all POD licenses to run in AG
mode.
Access Gateway default port mapping TABLE 7
Brocade Model Total Ports F_Ports N_Ports Default port mapping
VA-40FC 40 0–31 32–39 0–3 mapped to 32
4–7 mapped to 33
8–11 mapped to 34
12–15 mapped to 35
16–19 mapped to 36
20–23 mapped to 37
24–27 mapped to 38
28–31 mapped to 39
300 24 0–15 16–23 0, 1 mapped to 16
2, 3 mapped to 17
4, 5 mapped to 18
6, 7 mapped to 19
8, 9 mapped to 20
10, 11 mapped to 21
12, 13 mapped to 22
14, 15 mapped to 23
5100 40 0–31 32–39 0, 1, 2, 3 mapped to 32
4, 5, 6, 7 mapped to 33
8, 9, 10, 11 mapped to 34
12, 13, 14, 15 mapped to 35
16, 17, 18, 19 mapped to 36
20, 21, 22, 23 mapped to 37
24, 25, 26, 27 mapped to 28
28, 29, 30, 31 mapped to 39
Default port mapping
Access Gateway Administrator's Guide 27
53-1003126-01