Avocent DSView - Manual (Page 93)

Appendices 87
The following table lists the ANSI mode control sequences for VT100 terminal
emulation and indicates Avocent encoding/decoding support, where Yes =
supported and No = not supported.
VT100 ANSI Mode Control Sequences
Control Sequence Defi nition Encode/Decode
Esc [ Pn; Pn R Cursor Position Report No/No
Esc [ Pn D Cursor Backward No/Yes
Esc [ Pn B Cursor Down No/Yes
Esc [ Pn C Cursor Forward No/Yes
Esc [ Pn; Pn H Cursor Position No/Yes
Esc [ Pn A Cursor Up No/Yes
Esc [ Pn c Device Attributes No/No
Esc # 8 Screen Alignment Display No/Yes
Esc # 3 Double Height Line - Top Half No/No
Esc # 4 Double Height Line - Bottom Half No/No
Esc # 6 Double Width Line No/No
Esc Z Identify Terminal No/No
Esc = Keypad Application Mode No/No
Esc > Keypad Numeric Mode No/No
Esc [ Ps q Load LEDs No/No
Esc 8 Restore Cursor No/Yes
Esc [ ; ; Report Terminal Parameters No/No
; ; ;
; x
Esc [ x Request Terminal Parameters No/No
Esc 7 Save Cursor No/Yes
Esc [ Pn; Pn r Set Top and Bottom MarginsNo/No
Esc # 5 Single Width Line No/No
Esc [ 2; Ps y Invoke Confi dence Test No/No
Esc [ Ps n Device Status Report No/Yes
Esc [ Ps J Erase in Display No/Yes
Esc [ Ps K Erase in Line No/Yes
Esc H Horizontal Tabulation Set No/No
Esc [ Pn; Pn f Horizontal and Vertical Position No/Yes