Pro-Cut Warthog - Manual (Page 69)

WWW.PROCUTUSA.COM PG / Ø69
LATHE/PC will not communicate. Screen lower left reads “Disconnected.” Motor does turn on.
1. CHECK ALL WIRING CONNECTIONS. After making sure all are connected, cycle
the AC power to the lathe by unplugging it from the wall and plugging it in again.
2. At the lathe computer box, unplug the USB cable, wait a few seconds and then
re-seat the USB cable.
GYR TROUBLESHOOTING GUIDE
ISSUE
TROUBLESHOOT
Lathe will not run; computer is on.
1. Check power cord connections.
2. Check shut-off cam.
ISSUE
TROUBLESHOOT
Scanner will not respond
1. Check the scanner's USB cable connections.
2. Clean vehicle’s barcode / windshield.
3. Vary barcode scanner distance.
4. Approach barcode with scanner at a 30-degree angle.
ISSUE
TROUBLESHOOT