Pro-Cut Warthog - Manual (Page 45)

WWW.PROCUTUSA.COM PG / Ø45
Loosen the position lock knob.
Using the rotor centering pointer as a guide,
center the cutting head about the rotor.
Tighten position lock knob.
Adjust each arm's depth of cut as desired and
then lock each arm with its' lock knob. It is
not necessary to use much force on the tool
arm lock knobs. Finger snug is plenty.
TO USE THIS CUTTING HEAD:
1.
2.
3.
NOTE: Use only Pro-Cut Cutting Tips (50-742). Although other tips will fit the machine, only Pro-Cut tips have been specifically
engineered in tandem with the Pro-Cut lathe. Using a non-Pro-Cut tip may compromise lathe performance and result in poor
surface finish.
50-1200 CUTTING HEAD 1
2
3
Turn off the lathe to stop the rotor from
spinning and then fit the silencer/deflector
about the rotor, and secure the back end of
it under the retainer. This will help prevent
it falling away prematurely.