Pro-Cut Warthog - Manual (Page 17)

WWW.PROCUTUSA.COM PG / Ø17
It is important to start on the proper side. The Pro-Cut mounts directly to the hub of the vehicle.
With the lathe right-side up (FIG:1) the cutting head is to the right of the hub as you face the vehicle
wheel well. When machining a rotor, the cutting head is most often positioned where the caliper
rides. On a vehicle where the calipers ride in front of the hub, always start on the passenger side. If
the caliper rides to the rear of the hub, begin on the driver’s side.
When you flip the lathe to machine the opposite side of the vehicle (FIG:2), no inboard / outboard
cutting head adjustments are required since they were made in the upright position.
Lathe in upside-down position. You will need to flip the
lathe over into this position to machine one side of the
vehicle if there is a dust shield, or other interference be-
hind the rotor.
(NOTE* SPINDLE GUARD 50-1740 NOT
SHOWN FOR CLARITY.)
The Pro-Cut WART-
HOG machines both
front and rear rotors.
The lathe’s operations
do not change at all
in the rear of the ve-
hicle.
NOTE
Lathe in upright position. Note that adjustments to cut-
ting head are simpler in this position.
(NOTE* SPINDLE
GUARD 50-1740 NOT SHOWN FOR CLARITY.)
FIG:1 FIG:2