Pro-Cut Warthog - Manual (Page 15)

WWW.PROCUTUSA.COM PG / Ø15
ASSEMBLE THE TROLLEY
Open the trolley box and check contents against the parts diagram . If you are missing any parts, call Pro-Cut
immediately. Proceed with assembly, following the instructions enclosed in the box.
MOUNT THE LATHE TO THE TROLLEY
Once the trolley is assembled you will need to mount the lathe to the trolley. Locate receiver arm on trolley
so that lathe will be in upright horizontal position (with machined holes up) when it is installed, then lock the
disc-lock lever firmly.
1 ) Remove the lathe body from the shipping pallet and locate 4 bolts (35-289), and 4 washers (37-003), and
have ready for connection to trolley.
2 ) Find another person to help lift the lathe using the handles on either end, and insert the lathe mounting
bar into receiver on trolley. Secure with 4 bolts and washers noted in step #1.
Assemble the trolley com-
pletely then get assis-
tance from another person
to mount the lathe to the
trolley.
Cutting
Edge
Tip