Pro-Cut Warthog - Manual (Page 33)

WWW.PROCUTUSA.COM PG / Ø33
TROUBLESHOOTING
If the machine is having difficulty adjusting for lateral run-out, first assess the vehicle being serviced. If
lateral movement is rough or uneven due to damaged vehicle components, these components must be re-
paired or replaced before rotors are match-machined. It is also important that the machine be supported
by the trolley during adjustment.
LATERAL Run-out ADJUSTMENT The WARTHOG can be calibrated to adjust to tighter or looser standards.
CALIBRATION PROCEDURE
The Pro-Cut WARTHOG Rotor Matching System is calibrated with an accep-
tance number from the factory. Normally, this will never need to be changed.
Please call Pro-Cut Service Department before attempting calibration proce-
dure to confirm that this is the problem. To tighten the calibration you need to
lower the acceptance number. To
loosen the calibration, you need to raise the
acceptance number.
Please see pages 34 - 35 to raise or lower the acceptance number.