Yokogawa DR240 - Manual (Page 85)

7-9 IM DR231-11E
Output Format
7
7.8 A/D Calibration Data Output Format
A/D calibration data are output in the following format by the TS8 + “Device Trigger (GET)” +
LF command: This is effective only in the A/D calibration mode.
XZ A/D calibration data for the last slot
EN Output completion CrLf
CrLf
XZ
CrLf A/D calibration data for the first slot
Calibration data are output for every slot after the command to execute A/D calibration. The
output format is the same form as in the XZ command setting shown below.
XZ subunit number, slot number, DISPLAY, calibration item CrLf
All calibration items are output.
Range of outputting
The number of slots to which A/D calibration data are output is determined by the channels
specified by the LF command. For example, if channels 042 to 236 are specified by the LF
command, data from subunit 0, slot 4 to subunit 2, slot 3 are output.