Yokogawa DR240 - Manual (Page 36)

4-7 IM DR231-11E
Overview and Specifications of Ethernet Interface
4
4.4 Setting the IP Address
Configuring from the PC
Connect the PC and the DR as shown below. The PC must have the Data Acquisition Software 32
or the Data Acquisition Software 32 Plus installed.
Set the mode of the Ethernet module to configuration mode.
PC
Ethernet card
Ethernet module
Hub
10BASE-T cable
ETHERNET I/F
10BASE-T
DR
Setting procedures
Start the Data Acquisition Software 32 (comes with the DR) or the Data Acquisition Software 32
Plus (sold separately).
1. Switch on power of your PC and the DR, Startup DAQ 32 and select Software Configurator with
the Launcher toolbar.
2. Click the Network tab to display the setting screen for IP address, Subnet Mask, and Default
Gateway.
Configuration mode
setting
Communication mode
setting
3. Click the Check button to get the currently used settings. If this is the first time you use the DR,
initial values will get displayed.
4. If you click the digits in the IP address, Subnet Mask, or Default Gateway setting boxes, the
clicked part will be invertedly displayed, allowing you to change the value.
5. Enter the appropriate setting values for IP address, Subnet Mask, and Default Gateway.
6. After making the settings click OK, and again OK when a reconfirmation message appears, to
activate the new network address (IP address, Subnet Mask, and Default Gateway). Click Cancel
to return
7. Click OK when asked Close Network? to finish the setting.