Yokogawa DR240 - Manual (Page 37)

4-8 IM DR231-11E
4.5 Connection Methods
When Directly Connecting to the PC
If you are directly connecting the DR and the PC to read in the measured data, connect them through
a hub as follows.
PC
Ethernet card
Ethernet module
Hub
10BASE-T cable
PC
Ethernet card
Ethernet module
ETHERNET I/F
10BASE-T
DR
ETHERNET I/F
10BASE-T
DR
When Connecting to the Network
An example in which one DR and one PC are connected to the network is shown below.
PC
Ethernet card
10BASE-T cable
Network
Ethernet module
ETHERNET I/F
10BASE-T
DR
Note
• Depending on the condition of the network, the PC may not be able to read in all of the measured data.
• You can connect between networks over a router.
• Accessing a DR from multiple PCs at once will lower the communication performance.