Yokogawa DAQWORX - Manual (Page 26)

6 IM WX1000-01E
Introduction to Functions
The following sections provide a brief explanation of how GateMODBUS can be
used to acquire data from the UT351 temperature controller on DAQLOGGER,
how GateWT can be used to acquire measured data from Yokogawa’s WT1600
on DAQLOGGER, how GateMX/MW can be used to acquire measured data from
Yokogawa's MX100 Data Acquisition Unit, how measured data from Yokogawa
recorders can be acquired on DAQLOGGER, and how AddMulti software can be
used to acquire and save data on DAQLOGGER on a group-by-group basis.
DAQLOGGER
DAQLOGGER acquires measured or calculated data from recorders connected to
other recorders or PCs. Also, Gate software* (GateWT, GateMODBUS, GateMX/
MW etc.) can be connected allowing data acquisition from measuring instruments
including digital power meters (such as the WT1600), Modbus devices (such as
Yokogawa’s UT351/UT551 temperature controllers), and data acquisition units (such
as the MX100).
* The devices that can be connected differ depending on the Gate software installed.
AddMulti
AddMulti is a software program that allows you to connect data acquisition software
such as DAQLOGGER and simultaneously perform acquisitions under different
logging conditions. This function is called multilogging. For example, data acquired
from the WT1600 Digital Power Meter, data from a Modbus device (the UT351
temperature controller), and data from recorders can be divided into several groups
on DAQLOGGER, then each group can be logged and saved to a designated folder
at a specified timing. You can also mix data from the WT1600, Modbus device
(UT351), and recorders in a single group.
GateWT
GateWT is a software program that acquires data from WT series instruments and
transfers it to DAQLOGGER.
GateCONTROL
GateCONTROL is a software program that acquires data from temperature
controllers and signal converters that support data output via the Modbus/RTU and
Modbus/TCP protocols, and transfers the data to DAQLOGGER.
GateMX/MW
GateMX/MW is a software program that monitors measured data from MX100 data
acquisition units and transfers it to DAQLOGGER or remote monitors.