Yokogawa PC-Based MX100 User Manual
Mx100 data acquisition unit
Table of contents
Document Outline
- Contents
- Checking the Contents of the Package
- Function Introduction
- Signal Wiring of the MX100
- Attachment Position and Channel Numbers of the Input/Output Module
- Terminal Arrangement Markings on the Terminal Cover
- Wiring the Universal Input Module and DCV/TC/DI Input Module
- Wiring the Four-Wire RTD Resistance Input Modules
- Wiring the Strain Input Modules
- Wiring the Digital Input Modules (-D05, -D24)
- Wiring the Analog Output Modules
- Wiring the PWM Output Modules
- Wiring the Digital Output Module
- Connection to the Network
- Setup Procedures of the MX100 Standard Software
- Operations of the MX100 Standard Software
- Connecting to or Disconnecting from the MX100
- Setting the Acquisition Conditions of the Measured Data
- Setting Measurement Conditions
- Monitoring the Measured Data and Setting the Display
- Pausing the Updating of the Monitor Display and Reading Measured Values Using Cursors
- Recording the Measured Data
- Setting Alarms
- Digital Output
- Setting the Computation
- Saving/Loading and Printing of Setup Data (Project)
- Displaying Recorded Measured Data, Reading Values Using Cursors, and Statistical Computation over an Area
- Printing the Displayed Data
- Converting the Format of the Recorded Measured Data