Yokogawa PC-Based MX100 - Manual (Page 10)

10
IM MX100-0E
Flow of Operation during Installation
The figure below shows the general flow of operation when the MX100 is installed
initially.
Wire the input/output
modules
Operations on the MX100 Operations on the PC
Connect the network
cable
Connect the
power cable
Turn ON the
power switch
Set up the MX100
Standard Software
Set the network
parameters of the PC
Start the Integration
Monitor
Set the network
parameters of the MX100
Connect to
the network
Connect the MX100
Monitor screen display
Set the acquisition
conditions
Set the measurement
conditions
Monitor the
measured data
Change the
display conditions
Record the
measured data
Start the Viewer
Install the MX100
Display the
recorded data
See the Installation and
Connection Guide*.
See the Installation and
Connection Guide*.
(For a simple description of
the signal wiring,
see pages 15 to 23.)
Page 24
See the Installation and
Connection Guide*.
See the Installation and
Connection Guide*.
* MX100/MW100 Data Acquisition Unit
Installation and Connection Guide
(IM MX100-72E)
Page 25
Page 24
Pages 26 to 29
Pages 30 and 31
Set the monitor/record interval, record
start/stop conditions, etc.
Pages 32 to 34
Set the input mode, measurement
range, measurement span, etc.
Pages 37 to 41 Pages 35 and 36
Page 41
Pages 48 to 53
This Operation Guide and the Installation and
Connection Guide are abridged manuals.
They do not cover all the functions and operations.
They also do not cover the details of the precautions
and limitations of usage.
For a detailed explanation, see the following electronic
manuals contained in the manual CD-ROM.
• The functions, installation, wiring, and handling
procedures
MX100 Data Acquisition Unit User’s Manual
(IM MX100-01E)
• The functions and operations of the MX100
Standard Software
MX100 Standard Software User’s Manual
(IM MX180-01E)
Function Introduction