Yokogawa PC-Based MX100 - Manual (Page 25)

5
IM MX100-0E
Setup Procedures of the MX100 Standard Software
For details on the setup procedure, see the MX100 Standard Software User’s Manual (IM
MX180-01E). For the MX100 Standard Software system requirements, see “Connection
to the PC” in “Connection to the Network.”
Installing the MX100 Standard Software
Insert the MX100 Standard Software Setup CD-ROM in to the CD-ROM drive. The
language selection screen appears. Select the language and the setup program
automatically starts. If the installer does not automatically start, double-click SETUP.EXE
in the DISK1 folder in the English folder on the CD-ROM.
After the setup program starts, follow the instructions that appear on the screen.
In the middle of the installation, a dialog box shown below opens prompting you to enter
the serial number. The serial number is written on the label that is attached to the front of
the case for the MX100 Standard Software Setup CD-ROM.
Installation Result
When the software program is installed properly, the folder MX100 Standard is created
in the specified directory (C:\ by default). MX100 Standard is registered in the program
list and MX100 Standard (referred to as the Integration Monitor in this operation guide),
MX100 Viewer, and MX100 Calibration are registered under it.