Yokogawa PC-Based MX100 - Manual (Page 31)

1
IM MX100-0E
• Monitor interval setup example
As shown in the figure below, the waveform display area is shown for each monitor
interval.
Setting the Record Start/Stop Condition
Set the start condition for saving the measured data (computed data also if computation
channels are set to be recorded) to the hard disk (record start condition) and the stop
condition. For a description of the record start/stop operation, see page 41.
Immediately starts recording when the Record button
on the Monitor screen is clicked or Record is chosen
from the Acquisition menu.
Starts recording at the specified date/time
(year/month/day hours:minutes:seconds).
* For a description of the record start/stop condition Math, see the
MX100 Standard Software User’s Manual (IM MX180-01E).
Immediately stops recording when the Stop button on
the Monitor screen is clicked or Stop is chosen from
the Acquisition menu.
Stops recording at the specified date/time
(year/month/day hours:minutes:seconds).
Stops recording after the specified time
(hours:minutes:seconds) elapses after the recording
is started.
*
*
Setting the Save Destination and Name of the Record File
Select the hard disk drive of your PC for the save destination. Do not specify a storage
medium other than the hard disk or a network drive, as it may cause problems in terms of
performance. By default, the save destination is the Data folder in the MX100 Standard
folder where the MX100 Standard Software is installed.
The default file name is data. The extension is .mxd. You can also add record start date
and time to the file name as follows.
• When both the date and time are added: data-0314-1316 (recording started at 13
hours 16 minutes on March 14)
• When only the date is added: data-20030314 (recording started at March 14, 2003)
• When only the time is added: data-1316 (started recording at 13 hours 16 minutes)
Save destination
When selecting the save destination folder
* For a description of the File division and Comment items, see the
MX100 Standard Software User’s Manual (IM MX180-01E).
When adding the record start time to the file name
Default setting is data.
(The .mxd extension is automatically added.)
When adding the record start date to the file name
*
*
Operations of the MX100 Standard Software