Yokogawa PC-Based MX100 - Manual (Page 40)

40
IM MX100-0E
Displaying Marks
You can display marks in the trend waveform area (see the figure below). You can enter
a text to be attached to the mark (“Mark” by default) using up to 15 characters. Click the
Mark button or choose Mark Configuration from the Action menu. You can enter the
text in the dialog box that opens.
Mark
Mark setup dialog box
Text of the specified mark
Enter the text to be
displayed as a mark
Check here to display marks without displaying this dialog box
Pausing the Updating of the Monitor Display and Reading Measured Values
Using Cursors
Pausing and Resuming the Updating of the Monitor Display
Click the Pause button on the Monitor screen or choose Pause from the Acquisition
menu to stop the updating of the monitor display. When paused, the word “Pause” under
the button toggles between red and black. To resume the updating, click the
Pause
button on the Monitor screen or choose Pause release from the Acquisition menu.
Click
or
Choose
Note
Recording continues even when the updating of the monitor display is stopped.
Reading Measured Values Using Cursors
You can read measured values (computed values) using cursors when the updating of
the monitor display is paused. Click the position where you wish to read the value in the
waveform display area. If you wish to read another point simultaneously, drag the cursor.
Cursor A appears at the position where you first clicked; Cursor B appears at the position
where you released the mouse button. The measurement point is indicated by a yellow
circle at the cross point of the cursor and waveform.
Change the display area
Time at Cursor B
Time at Cursor A
Scroll bar
Scroll button
Measurement point
Cursor B
Cursor A
Cursor movement button
Time between Cursors A and B
(value B) − (value A)
Readout value of Cursor B
Readout value of Cursor A
Channel number
Waveform display color
Operations of the MX100 Standard Software