Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 8)

-8-
Digital Electronics Corporation
8-2-52 Nanko Higashi, Suminoe-ku, Osaka
559-0031, Japan
URL : http://www.pro-face.com/
Note
Please be aware that Digital Electronics Corpora-
tion shall not be held liable by the user for any dam-
ages, losses, or third party claims arising from the
uses of this product.
When connecting the RS-232C isolation unit, the following two settings are made in the
Display’s Offline mode or using the screen creation software GP-Pro EX.
-Setting the Display’s communication method to RS-232C
-Setting the COM1 port’s number 9 pin to VCC
In the case of the operation in the Offline mode, change it with [Peripheral Settings] of
[Device PLC/Settings]. For the software(GP-Pro EX)’s operation, refer to “GP-Pro EX
Device/PLC Connection Manual”.
„ Attaching the unit to the panel
When attaching the unit to a panel other than the Display main unit, attach it at two
points referring to the diagram below. Make holes suitable for the screws referring to
the diagram below. For attaching it, refer to “„Attaching the unit directly to the
Display”.
Unit mm:[in.]
75[2.95]
φ 9± 0.1[0.35±0.00]
0.7± 0.1[0.03±0.00]
(2.7[0.11])
φ 6.5± 0.1
3.3±
0.05[0.13±0.00]
4
+0 - 0.2
M3 SCREW
[0.16 ]
+0.00
- 0.01 [0.26±0.00]
2-M3[0.12] or less
5 Display side settings