Warning – Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" User Manual
Page 33

34
Eng
lis
h
Standards
The GP unit is manufactured in accordance with:
•
Standard UL 508 and CSA C22.2 n°142 for Industrial Control Equipment
•
Standard ANSI/ISA - 12.12.01 and CSA C22.2 n°213 for Electrical
Equipment for Use in Class I, Division 2 Hazardous Locations
WARNING
RECOMMENDATION FOR RESTRICTED AREAS
• Verify the power, input, and output (I/O) wiring are in accordance with Class
I, Division 2 wiring methods.
• Substitution of any component may impair suitability for Class I, Division 2.
• Do not disconnect equipment while the circuit is live or unless the area is
known to be free of Ignitable concentrations.
• Securely lock externally connected units and each interface before turning
on the power supply.
• The USB (mini-B) interface is for temporary connection only during
maintenance and setup of the device. Do not use, connect, or disconnect
USB (mini-B) cable unless area is known to be non-hazardous.
• Potential electrostatic charging hazard: wipe the front panel of the terminal
with a damp cloth before turning ON.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
Note:
•
For use in Pollution Degree 2 environments.
•
For use on a flat surface of a Type 1, Type 4X (Indoor Use Only)
or Type 13 Enclosure.
•
24V DC input unit must be used with a Class 2 power supply.
•
Suitable for use in Class I, Division 2 Groups A, B, C, and D
Hazardous Locations.
- GP4500R - 10.4 Standard HMIs with Rear Mounting Options" GP4400R - 7.5 Standard HMI with Rear Mounting Options" GP4300R - 5.7 Standard HMI with Rear Mount" GP4300M - 5.7 Modular HMI" GP4200M - 3.5 Modular HMI" GP4500 - 10.4 W Model HMI" GP4400 - 7.0 W Model HMI" GP4300 - 5.7 W Model HMI" GP4200 - 3.5 W Model HMI" GP4600 - 12.1 Standard HMIs" GP4500 - 10.4 Standard HMIs" GP4400 - 7.5 Standard HMI" GP4300 - 5.7 Standard HMI" GP4200 - 3.5 Standard HMIs"