ADTRAN XRT - Manual (Page 78)

Appendix C. Status Buffer Messages
66 Express XR/XRT Quick Start Guide 61200.153L1-1
AutoSwitch YYY
Switch type YYY detected during AutoSpid determination.
(YYY can be DMS, NI-1, or AT&T)
Back to online
Express XR went back on line.
Bad async BPS
The Bonding protocol determined that the selected asynchro-
nous bit rate is not supported.
Bad AT numeric
User issued an AT command with an argument that was out of
range.
Bad call type
Express XR placed a call with an improper call type.
Bad DTE Baud
The DTE bit rate does not match a valid bit rate for the protocol
selected.
BAD_INFO_ELEM
Call control error.
Bad phone number
Express XR/XRT attempted to call an invalid phone number.
BEAR_CAP_NOT_AVAIL
The bearer channel requested is not available.
BEARER_CAP_NOT_AUTH
Bearer capability requested is not authorized.
Bearer Mode?
Incoming call is not of a type the Express XR/XRT can accept.
Bearer Info Cap?
Incoming call information transfer capability is not known.
BONDING (+/-XXX)
The amount of bytes or corrected delay between the B2 and B1
Bearer channels (XXX can range from -8000 to +8128).