ADTRAN XRT - Manual (Page 35)

61200.153L1-13 Express XR/XRT Quick Start Guide 23
Chapter 2. Installation
14. In the Make a New Connection menu, enter the number to
dial.
15. Click NEXT.
16. Click Finish to complete the new connection setup.
17. To use this connection, select it from My Computer, Dial-Up
Networking . Windows dials the number using the modem
and properties as configured. When using the connection
the first time, network log in information such as the user
name and password must be entered. This information
should be provided from the Internet Service Provider.
MACINTOSH CONFIGURATION
A Macintosh can be used to configure the Express XR/XRT by
using a terminal emulation package such as MicroPhone Pro™
and following the VT 100 configuration directions.
VT 100 TERMINAL EMULATION
The Express XR/XRT can be configured using any communica-
tions package supporting VT 100 terminal emulation. To enter
into the menus, type AT!V Enter. To go to a particular menu,
press the hot key sequence for that menu. The main branches of
the menu tree and their hot keys are as follows:
STATUS (Ctrl + V)
TEST (Ctrl + T)
CONFIG (Ctrl + C)
DIAL (Ctrl + D)
Ensure that the communications package is configured to pass these
Control Sequences through to the Express XR/XRT.
To exit the menus, press Ctrl + X. The Ctrl + X command also
places the unit back on-line if a call is connected.
Some features in the Express XR/XRT do not immediately take
effect upon selection. This prevents unintentional
reconfiguration of the Express XR/XRT during an active call.
Items such as Protocol and Call Type take effect only at the
beginning of a new call.