Alamo Interstater TS-100A - Manual (Page 66)

© 2004 Alamo Group Inc. Page 9 - 2
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Tractor / Mower Mounting Specifications
New Holland TS100A Cab/2wd As of: 4-16-04
10.00-16 Max Front Tire
18.4-30 Max Rear Tire
Mainframe: Right Hand Only (5" Offset Right) ………………....................02981068
Comp Crate: RH Only w/Aux Pump ………………………….................... 02981075
Mainframe: Dual Wing (5" Offset Left & Right) …….....……..................... 02980935
Comp Crate: Dual Wing w/Aux Pump ……………………….....................02980823
Replacement Fuel Tank (46 gal/Req’d for Dual) ………………................ 02980938
Options:
Lift Chain Kit (See Spec Below) …………………………….......................02980514
Specifications:
1. These mount kits include exhaust modification kit #02980717 which allows the vertical A-post
style exhaust to be moved in approximately 8-1/2" for head transport clearance. In addition,
a portion of the tractor’s exhaust mounting bracket must be cut away to allow clearance for
the path of the head lock-up lug.
2. These kits also include a battery relocation bracket which shifts the battery up and back.
(See Figure 1) Furthermore, as a result of the cylinder mount position, the battery bracket will
no longer hinge outward. However, the battery can still be accessed and even removed with
the assistance of one additional person.
3. For dual wing mowers, the factory installed fuel tank must be replaced with the one listed
above to permit clearance for the cylinder mount (See Figure 2).
4. Full Interstaters must be ordered with a 96" centered rear head. Right hand only models can
be ordered with a 96" centered or 88" offset right 8.5" rear head. Two lift chains are
recommended for centered heads, while offset heads should only be ordered with one.
5. The mainframe should allow approximately 10- 3/4" of ground clearance with the maximum
tire size listed above.
6. As with most dual wing Interstaters, the left wing must be lowered for ingress/egress to the
tractor platform.
7. For dual wing models, the left hand tractor steps must be removed. A replacement step is
provided with the fuel tank kit. For dual and single wing models, the right hand steps must be
removed for clearance as well. Ingress/egress on the right is otherwise blocked by the control
stand.
8. The pump mount in this kit is assembled with a carrier bearing to extend the life of the driveline
and pulley weldment.
9. Rear tires dimensionally larger than 18.4-30 may interfere with the replacement fuel tank and/
or revised battery box position. Adjusting the rear wheels to a “full spread” may resolve such
issues, however this has not been properly reviewed by our engineering team at this time.
10. These mount kits should also fit 4 wd tractors with 12.4-24 maximum front tires. However,
special wing heads must be fabricated such that the cooling tube return fitting is moved out
12" for front tire clearance during transport. An engineering change request (ECR) must be
submitted to revise the heads prior to accepting any 4 wd orders. Clipped foot guards are also
recommended for this application.