Alamo Interstater TS-100A - Manual (Page 15)

© 2004 Alamo Group Inc. Page 2 - 5
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Main Frame Dual / Single Wing
Prepare 4 Spool Control Valve:
1. Remove standard control Handles. When
using the remote control cables and handles the
standard handles must be removed and discarded.
This is done by removing the C-Clips and pins that
hold the handles to the valve body and the C-clips
and pins that hold handles to the spools. (See Figure
12)
2. Bolt Valve Mounting Bracket to Mainframe .
The valve mounting bracket is bolted to the Right
Hand side of the tractor. It is bolted to the mainframe.
There are two different sets of hole in valve mounting
bracket, this allows the location of the valve to be
varied.
3. Install The Cylinder Control Valve to Valve
Bracket. The control valve is mount to the valve
bracket using two bolts. These two bolts is all that will
be needed to mount valve to valve bracket. (See
Figure 14).
Figure 12
Figure 13
Figure 14
Valve mounting bolts (2
used)