Rear three point mower, Figure 1 figure 3 figure 2 figure 4 – Alamo Interstater TS-100A User Manual
Page 58
© 2004 Alamo Group Inc.
Page 8 - 2
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Rear Three Point Mower
Connection:
1.
The Rear Mower is a standard Three Point
Hitch mounted mower that is PTO driven through a
driveline. It will be sent already assembled with the
driveline tied to it. (See Figure 1)
2.
Connect Lower Hitch Pins.
The lower hitch
pins connect to the lift arms of the tractor with click
pins, these pins are furnished with the mower. (See
Figure 2). It is best to connect the lower arms of the
three point first. You can use the lower arms to
3.
Connect Upper Hitch Pin.
The upper hitch pin
will connect to the top three point adjustable Link with
a pin and click pin. The Top Link is furnished with the
tractor not with the mower. The Top Link is adjustable
in length and is used to level the mower. (See Figure
3)
4.
Connect Driveline . The Driveline arrive tied to
the mower (See Figure 1 & 4). Cut the ties loose from
mower. Connect the clutch end of the driveline to the
mower, the clutch is retained to tgearbos input shaft
by a clamp yoke on clutch hub. Slip the clutch onto the
input shaft untill holes in clamp yoke are aligned with
the grooves in the inbut shaft. Install and tighten the
two bolts and nuts. The QD Yoke end connect to the
Tractor PTO.
Rear Three Point Mower
Figure 1
Figure 3
Figure 2
Figure 4