IEI Integration ECN-680A-H61 - Manual (Page 48)

ECN-680A-H61 Em b e d d e d S ys te m
P a g e 34
S te p 4: Locate the RJ-45 connectors. The location of the LAN connector is shown in
Chapter 1.
S te p 5: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the ECN-680A-H61. See
360H
Figure 3-25.
Figure 3-25: LAN Connection
S te p 6: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the RJ-45 connector. S te p 0:
3.11.5 DB-9 S e ria l P o rt Co n n e c tio n
There are two RS-232 DB-9 connectors and one RS-422/485 DB-9 connector of the
ECN-680A-H61 for serial device connection. Follow the steps below to connect a serial
device to the DB-9 connector of the ECN-680A-H61.
S te p 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 1.
S te p 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the rear panel. See Figure 3-26.