IEI Integration NANO-QM57A - Manual (Page 61)

NANO-QM57A EPIC SBC
Page 49
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding NANO-QM57A external peripheral interface connector
making sure the pins are properly aligned.
4.8.1 DVI Display Device Connection
The NANO-QM57A has one female DVI-I connector and one female DVI-D connector on
the external peripheral interface panel. The DVI connectors are connected to digital
display devices. To connect a digital display device to the NANO-QM57A, please follow
the instructions below.
Step 1: Locate the DVI-I connector. The location of the DVI-I connector is shown in
another chapter.
Step 2: Align the DVI-I connector. Align the male DVI-I connector on the digital display
device cable with the female DVI-I connector on the external peripheral
interface.
Step 3: Insert the DVI-I connector . Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the NANO-QM57A. See Figure 4-15.